python_code_samples_network/netmiko-interface-example at master · brixcode/python_code_samples_network

Using Netmiko to work with Interfaces

These example scripts use the Netmiko Python library to interact with a device through CLI

These Python scripts leverages Netmiko to:

• Create Loopback 103
• Retrieve details about Loopback 103
• Delete Loopback 103

This script has been tested with Python 3.6, however may work with other versions.

DevNet Sandbox

This script targets the IOS XE DevNet Always On Sandbox that leverages a CSR1000v as a target.

To execute this script against a different device, create a new device dictionary in device_info.py for your device. Then import this new dictionary instead of ios_xe1 in the scripts.

Requirements

Python

• netmiko

Getting Started

• Clone the Python Examples and change into the directory.

  git clone https://github.com/CiscoDevNet/python_code_samples_network.git
  cd python_code_samples_network
  cd netmiko-interface-example

• Create and activate a virtualenv

  Windows - recommendation to use git-bash terminal
  py -3 -m venv venv
  source venv/Scripts/activate
  
  MacOS or Linux
  python3.6 -m venv venv
  source venv/bin/activate
  

• Install the requirements

  pip install -r requirements.txt

• Run the scripts

  # Run the get script to retrieve interface
  $ python netmiko-get-interface.py
  
  # Output - Interface not there yet...                                                ^
  % Invalid input detected at '^' marker.
  
  There was an error, Loopback103 might not exist.
  
  # Run the create script to create interface
  $ python netmiko-create-interface.py
  
  # Output - what was configured
  The following configuration was sent:
  config term
  Enter configuration commands, one per line.  End with CNTL/Z.
  csr1000v(config)#interface Loopback103
  csr1000v(config-if)#description Demo interface by CLI and netmiko
  csr1000v(config-if)#ip address 192.168.103.1 255.255.255.0
  csr1000v(config-if)#no shut
  csr1000v(config-if)#end
  csr1000v#
  
  # Run the get script again
  $ python netmiko-get-interface.py
  
  # Output - there it is!
  Building configuration...
  
  Current configuration : 116 bytes
  !
  interface Loopback103
   description Demo interface by CLI and netmiko
   ip address 192.168.103.1 255.255.255.0
  end
  
  The interface Loopback103 has ip address 192.168.103.1/255.255.255.0
  
  # Run the delete script to remove the interface
  $ python netmiko-delete-interface.py
  
  # Output - what was sent to remove the interface
  The following configuration was sent:
  config term
  Enter configuration commands, one per line.  End with CNTL/Z.
  csr1000v(config)#no interface Loopback103
  csr1000v(config)#end
  csr1000v#